This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
dev:dg_in_a_box:diary [2018/02/27 20:33] – deva | dev:dg_in_a_box:diary [2018/04/17 21:08] (current) – [2018-04-17] suhr | ||
---|---|---|---|
Line 3: | Line 3: | ||
Future: | Future: | ||
+ | * http:// | ||
* https:// | * https:// | ||
* http:// | * http:// | ||
+ | * BCM SPI driver for userspace SPI (faster than spidev): [[https:// | ||
+ | * Raspberry Pi SPI speed table: [[https:// | ||
+ | * https:// | ||
+ | * Kicad with Spice integration: | ||
+ | |||
+ | =====2018-04-17===== | ||
+ | |||
+ | We made initial schematic in kicad. | ||
+ | |||
+ | Next define electric bla bla in pcm3168A component. Make sure that every pins are connected to something (mark unused as unused). Continue until electrical rule check is passed. | ||
+ | |||
+ | When this is done figure out how to make PCB. | ||
=====2018-02-27===== | =====2018-02-27===== | ||
Line 12: | Line 25: | ||
http:// | http:// | ||
+ | We are considering using the iCE40 Ultra (iCE5LP4K) instead of the iCE40HX8K. | ||
=====2018-01-23===== | =====2018-01-23===== | ||
Somewthing about blocking and non-blocking assignment in verilog: | Somewthing about blocking and non-blocking assignment in verilog: |